Water Softener Installation in Edmonton

Inside the tank is a bed of resin beads carrying sodium ions. As hard water flows through, calcium and magnesium — which hold a stronger charge — trade places with sodium and stay behind on the resin. The water leaving the tank is soft.

When the resin fills with hardness minerals, the softener regenerates: a brine solution drawn from the salt tank flushes the calcium and magnesium to the drain and recharges the resin. Modern metered systems regenerate based on water actually used, not on a clock, which is why they use far less salt and water than units from a decade ago.

A softener that’s undersized regenerates constantly, wastes salt and water, and wears out early. Oversized units sit idle between cycles, letting the resin bed channel and foul. Neither problem shows up on a spec sheet.

Correct sizing multiplies your measured hardness by daily household water use to find the grain capacity you need between regenerations. That’s a five-minute calculation — but only once someone has actually tested your water and asked how many people live in the home.

Most softener installs take two to four hours. We shut off the main, cut in a bypass so the system can be serviced without shutting down the house, plumb the unit, connect the drain line with the required air gap, and load the first bags of salt.

Before we leave we test the treated water in front of you, set the regeneration schedule, and show you how to add salt and use the bypass. Floors get protected and the mechanical room is left tidier than we found it.

Book a whole-home water softener installation and we include a reverse osmosis drinking water system, installed free. That’s soft water through the house plus bottled-quality water at your kitchen tap in one visit.